Oxygen Sensor For Chrysler Sebring 2.5L 2.4L 2000-1997 Downstream
- Item condition:
- New
- Ended:
- Jan 17, 00:22 PST
- Price:
- $19.15 View item
- Shipping:
- FREE
- Item location:
- Ontario,CA,USA
- Ships to:
- Worldwide
Item specifics
-
- Brand:
- Generic
-
- Manufacturer Part Number:
- OS01139
-
- Interchange Part Number:
- ES20041 23108 SG213 234-4028
-
- Other Part Number:
- 213-1369 OS885 13151 75-3350
-
- Warranty:
- 1 Year
-
- UPC:
- Does not apply
-
- EAN:
- Does not apply
-
- Position:
- Please Check the Notes on Compatibility
-
- Wire Quantity:
- 4
-
- Sensor Type:
- Heated
-
- Connector Gender:
- Female
-
- Wire Harness Length:
- 12.2
-
- Thread Diameter:
- 0.708
-
- Quantity Sold:
- 1 PCS
-
- FITS:
- If you not sure fit or not please contact us
- Home
- New Arrivals
- Ending Soon
- Feedback
- Contact Us
Store Categories
- Water Pump
- Fuel Pump
- Hub Bearing Assembly
- CV AXLE
- Other
Oxygen Sensor For Chrysler Sebring 2.5L 2.4L 2000-1997 Downstream
PRODUCT FEATURES
- 100% High quality brand new.
- 100% factory tested to meet or exceed all original equipment specifications.
- Quality components for proper fit and long-life performance.
- Each sensor has application specific design to ensure a perfect fit for easy installation.
Q: Why does the oxygen sensor have false alarm, after installation ?
A: The clearing of the errors can be obtained on most systems when the vehicle battery is disconnected for at least 60 seconds. The assignment of the new sensor parameters is done automatically when the errors are cleared, but in some systems a short adapting tour is required. In this case the vehicle has to be driven on the road for some 10-15 minutes, in order to have the ECU adapt itself to the new sensor.
Q：How should I install oxygen sensor ?
A: The following is the installation instructions: Use the correct part number as listed in the application catalogue ,Do not use sensor if i has been dropped ,Remove protection cap just prior to installation;
Firstly install sensor body ensuring lead wire is not twisted or bent , Do not use impact wrench or socket type wrench to install sensor ,M18 sensors - install finger tight then 1/2-3/4 turn with a wrench (35-45Nm) ;
Then connect and route lead wire as originally installed , Do not allow lead wire to touch exhaust manifold or any other hot component ,Do not apply any substances...
